CRUSH BOSS™ 6356 HORIZONTAL SHAFT IMPACTOR: Feed Opening of 38” x 57”, Four Bar Rotor with Reversible Blow Bars, Adjustable Primary and Secondary Anvil Assemblies Hydraulic Assist, Hydraulic Lid Opening

ELECTRIC MOTOR DRIVE: Twin 250 HP Motors, 480 V, 3 Phase, 60 Hz, V-Belt Drive & Guards

SIMPLICITY 57” X 20’ VIBRATING GRIZZLY FEEDER: 5’ Long Grizzly Section, A/R Replaceable Liners, 40 HP Electric Motor with V-Belt Drive and Guard, Skid Mounted Support Structure with Load Hopper (Removable for Travel)

60” UNDER CRUSHER CONVEYOR: 30 HP Electric Motor, Dodge S-M-R with V-Belt & Guard, Lagged Head Pulley, Wing Type Tail Pulley, 3 Ply Conveyor Belting, Rubber Impact Slider Bed in Receiver Section (Removable for Travel)

HYDRAULIC SYSTEM: Gas Engine Powered Hydraulic System with (4) 36” Tall Jacking Legs with Stiff Arm - Also Operates Hydraulic Lid Opening of Crusher and Anvil Assemblies, Complete with Valve and Lines

TRIPLE AXE CARRIER: Heavy Duty Chassis with  Support Legs, (12) 11 x 22.5 Tires and Rims, Air Brakes, Mud Flaps, Lights and King Pin- Service Walkway on Both Sides of Crusher, Feed Inlet Chute, Grizzly By-Pass and Discharge Hopper

OPTIONAL
CATERPILLAR DIESEL 820KW GENERATOR: Skid Mounted, Heavy Duty Radiator, Air Intake System, Block Heaters

SWITCHGEAR VAN / CONTROL TOWER: Crusher Soft Start with By-Pass Contactor, (2) Main Disconnects, (10) Starters with O/L Protection, 120 Volt Transformer, 50 HP Variable Frequency Drive, 6’ X 8’ Control Tower with A/C – Heat Operator Control Station, Hydraulic Raise and Lower

PEERLESS 16 TIRE SUSPENSION: Heavy Duty Frame and Leg Supports (16) 11 x 22.5 Tires and Rims

Equipment specs are subject to change based on component availability.